-
Entombing that mess with a squirt of hot melt glue
-
The general idea is to put all the thermocouple beads in close proximity so they share the same temperature…
-
I have a motley assortment of meters that allegedly read temperature from Type K thermocouple beads.
-
None of those metal parts has any provision to control a static charge accumulation, which means the charge will increase until one of two events transpires…
-
It makes the logic supply vulnerable to glitches induced by motor current switching.
-
This modification provides separate +12 V power wires to the Extruder and Heated Build Platform heater MOSFETs.
-
Molex connector pins aren’t rated for that much current, so the +12 V supply arrives at the board in poor condition.
-
A hack that’ll cause OpenSCAD to STFU and just start up.
The Smell of Molten Projects in the Morning 