-
The Step2 rolling garden seat took an untimely fall
-
With the feed rate reduced to some unknown value and the flow continuing at the original volume, each thread endpoint accumulates an oversized turd.
-
These 3D printed plates are just the latest in a long series of attempts to distribute the stress over a larger area.
-
This is a proof-of-concept lashup of a circuit to shut off the Thing-O-Matic’s power should the Thermal Core overheat.
-
I realized I could just print out a panel with the holes already in place…
-
The locking pin holder often teleported itself inside the vacuum cleaner.
-
By a quirk of the circuitry, that backfeeds +5 V into the +12 V supply.
-
Anyhow, it seems one of the streetlights was a bit too close to the corner.
The Smell of Molten Projects in the Morning 