-
Entombing that mess with a squirt of hot melt glue
-
Light hitting any shiny surface is reflected deeper into the notch between two blades
-
It just barely meets both its product description and the gas valve’s minimum current
-
Anything sticking out can be sanded off
-
When you get something wrong, you can hear the crash
-
Because it need not withstand much lateral force and will get used only a dozen-ish times
-
Having occasionally been in need of a lathe chuck stop, I finally cleared that project off the heap: These are definitely not up to commercial standards, but also don’t cost fifty bucks each. A trio of 4×2 mm neodymium disk magnets stick the stop to the chuck (and to each other) with enough force to […]
The Smell of Molten Projects in the Morning 