-
The double-sided tape holding these to their screws isn’t continually compressed
-
The main shape now has a 2 mm taper to ease the magazine spring past the upper edge of the block
-
Repeated heating took the starch right out of that poor spring
-
It’s producing reasonable quality stuff again
-
The LEDs don’t have quite enough room inside for that mount to tilt as I wanted
-
It doesn’t seem so bad from the outside
-
In this application, the 3D printer’s hand-knitted look is desirable
-
Something Went Wrong during the elaborate dance
The Smell of Molten Projects in the Morning 