-
Entombing that mess with a squirt of hot melt glue
-
The clock dumps the ADC values in hexadecimal, which gnuplot can’t handle, so a bit of preprocessing is in order.
-
Flying in a hallway full of people must be bewildering…
-
I’d expect the thickness to be pretty well controlled over a few feet of sheet, but that’s not how things went down.
-
The brass tube “locating pins” work surprisingly well.
-
He was content to watch us go by
-
Crude, but good enough for this purpose.
-
The general notion is to flycut about 2/3 of the length of the panel, then slide it far enough to cut the remainder.
The Smell of Molten Projects in the Morning 