-
Of late, the magnetic stirrer mixing my morning cocoa occasionally doesn’t start spinning when I turn it on, which calls for some investigation. Removing the four obvious screws concealed under the rubber feet and prying off bottom cover reveals the trivial innards: The speed adjustment pot holds the little circuit board in place, with the…
-
Although you might think removing those two screws would let you get into the sensor compartment and replace the sensor without any further fuss, that is not the case
-
Remember to use screws about 4 mm longer than the ones you took out
-
The light hasn’t been staying in its Happy Place™
-
The smoked acrylic shape emerged from the remnants of a Genuine IBM Printer stand
-
What it does do is warp the antenna’s pattern just enough
-
Having once again found a roller wandering around when I put the turntable back in
-
Installing my pull-out keyboard / trackball tray in place of its drawers
The Smell of Molten Projects in the Morning 