Advertisements

Monthly Science: WWVB Reception Sample

Further results from the SDR-based WWVB receiver:

60 kHz Receiver - preamp HIT N3 Pi3 - attic layout

60 kHz Receiver – preamp HIT N3 Pi3 – attic layout

Seven hours of mid-January RF, tight-zoomed in both frequency and amplitude, from 0350 to 1050 local:

WWVB waterfall - N3 - 2017-01-24 1050 - composite

WWVB waterfall – N3 – 2017-01-24 1050 – composite

The yellow line of the WWVB carrier comes out 2 ppm high, which means the local oscillator chain is 2 ppm low. We know the WWVB transmitter frequency is exactly 60.000 kHz, translated up by 125 MHz to the N3’s tuning range; you can, ahem, set your clock by it.

The blue band marks the loop antenna + preamp passaband, which isn’t quite centered around 60.000 kHz. Tweaking the mica compression caps just a bit tighter should remedy that situation.

Given that input, a very very tight bandpass filter should isolate the WWVB carrier and then it’s all a matter of fine tuning…

Advertisements

,

  1. Leave a comment

Spam comments vanish. Comment moderation may cause a delay.

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s