The Smell of Molten Projects in the Morning

Ed Nisley's Blog: Shop notes, electronics, firmware, machinery, 3D printing, laser cuttery, and curiosities. Contents: 100% human thinking, 0% AI slop.

Laser Cutter: Test Cuts

Just to see if all the laser parts once again fly in formation, I cut a defunct cotton shirt into shop wipes:

Laser cutter - first cuts after move
Laser cutter – first cuts after move

Which worked as before:

Laser cutter - more wipes
Laser cutter – more wipes

Not that I need more wipes, but in this case the process is more important than the product.

Looks like I can start using the laser cutter again … whew!

Comments

One response to “Laser Cutter: Test Cuts”

  1. Laser Cutter: Fourth Corner Adjustment – The Smell of Molten Projects in the Morning Avatar
    Laser Cutter: Fourth Corner Adjustment – The Smell of Molten Projects in the Morning

    […] recently spot-checked the alignment and not seen any odd behavior on another platform-spanning project, this was puzzling. Given that the laser recently survived a move from one Basement Shop to […]