The New Hotness

The Tektronix Circuit Computer sports the most ancient of many Tektronix logos:

It’s a bitty thing, with the CRT about 0.7 inch long, scanned directly from my original Tek CC.

Import the PNG image into FreeCAD at 0.2 mm below the XY plane, resize it upward a smidge so the CRT is maybe 0.8 inch long, then trace “wires” all over it:

Given FreeCAD’s default gradient background, the wires definitely don’t stand out by themselves:

Several iterations later, the vectorized logo sits at the correct angle and distance from the origin at the center:

The cheerful colors correspond to various “groups” and make it easier to find errant vectors.

Rather than figure out how to coerce FreeCAD into converting wires into proper G-Code, export the vectors into a DXF file and slam it into DXF2GCODE:

Export as G-Code, iterate around the whole loop a few times to wring out the obvious mistakes, indulge in vigorous yak shaving, eventually decide it’s Good Enough™ for the moment.

Protip: set DFX2GCODE to put “0” digits before the decimal point to eliminate spaces between the coordinate axes and the numeric values which should not matter in the least, but which confuse NCViewer into ignoring the entire file.

Tinker the script running the GCMC source code to prepend the logo G-Code to the main file and it all comes out in one run:

That’s the top deck, laminated in plastic, affixed to a Cricut sticky mat on the MPCNC platform, ready for drag-knife cutting.

Assembled with a snappy red hairline:

Isn’t it just the cutest thing you’ve seen in a while?

It needs more work, but it’s pretty close to right.