Tour Easy Creaking: Seat Stay

Over the course of a few days, my Tour Easy recumbent developed a slight squeak that turned into a definite creak, then the seat started shifting slightly under hill-climbing forces. Of course, no force I could apply in the garage caused the slightest squeak / creak / motion. A decade ago this was due to a sheared screw at the dropout, but everything seemed to be in good order.

So I applied a drop of penetrating oil to each of the many joints in the seat hardware, went on a few more rides, and eventually the seat started moving with normal pedaling forces.

The left strut clamp looked fine:

Tour Easy seat stay - left side
Tour Easy seat stay – left side

OK, it looks grubby. I’d rather ride than lick my bike clean.

The right clamp definitely showed signs of motion:

Tour Easy seat stay - right side slip
Tour Easy seat stay – right side slip

I extracted the strut assembly, degreased the clamps, reinstalled in reverse order, replaced the nuts, snugged everything down, and it’s all good again:

Tour Easy seat stay - renutted
Tour Easy seat stay – renutted

Yeah, I should have replaced those screws, but I didn’t even have to take the wheel off, sooooo