OMTech 60 W Laser: Spike Plates

Mash all these together:

To get a cardboard spike plate:

Laser spike plate - pristine
Laser spike plate – pristine

The punk spikes stick to a layer of ordinary masking tape across the back surface which lets them sit flat on the honeycomb and support a sheet parallel to the platform. They’re nominally an inch tall, which works out to a very consistent 24 mm, and come with a matching set of 6 mm M3×0.5 truss-head screws now residing in a ziplock bag against future need.

The spike plate works well under thin paper-like sheets requiring high cutting speed and low power, where the defocused beam just scorches tracks across the cardboard without setting it on fire:

Laser spike plate - scarred surface
Laser spike plate – scarred surface

Nota bene: a cardboard sheet makes a terrible backing plate under material requiring slow speed and high power, like MDF / plywood / acrylic, where the cloud of combustible gases under the victim forms a very effective flamethrower. You have been warned.

Obviously, you need not fill every hole. Leaving some holes vacant doesn’t (seem to ) allow much smoke removal downward through the honeycomb, perhaps because there’s insufficient perimeter area to get enough wind into the center section.

Eventually, the cardboard becomes sufficiently scarred to justify making another one, which is easy enough:

Laser spike plate - hole cutting
Laser spike plate – hole cutting

The motivation for raising the target above the platform is to provide good airflow to remove the smoke / fumes / smog from the area, thereby reducing unsightly deposits on the lower surface. Given decent airflow across the platform, this works surprisingly well:

Laser spike plate - smoke plumes
Laser spike plate – smoke plumes

That picture comes through the laser’s tinted polycarbonate window, so it’s somewhat blurred, but shows smoke streamers emerging from the victim’s corrugations and across its surface.

All in all, it’s quick, easy, and effective.