OMTech 60 W Laser: Beam Alignment Check Targets

The canonical beam alignment target seems to involve tape stuck on the mirror bracket:

OMTech 60W laser beam test - tape target
OMTech 60W laser beam test – tape target

With a full-power beam burned through it:

OMTech 60W laser beam test - mirror 1
OMTech 60W laser beam test – mirror 1

The roll of “white masking tape” supplied by OMTech turned out to be knockoff tapeless sticky adhesive film. After sticking a length to the mirror bracket, the white backing tape peels right off, leaving the adhesive film stuck to the bracket. Well, my tapeless sticky roll was running low, so this roll won’t go to waste.

A laser cutter can make intricate paper doodads, so I conjured better targets from the Vasty Digital Deep:

OMTech 60W laser - beam alignment - 2022-03-22
OMTech 60W laser – beam alignment – 2022-03-22

They’re burned into an ordinary manila file folder in “dot mode”: 2 ms pulses at 30% power separated by 0.25 mm. The 1 mm graticule locates the beam relative to the center, which is pretty close to the actual center of the opening, because the outer 17 mm cut fits neatly into the 17.5 mm hole. The label tells you where it goes and which line should point up.

Your mileage will vary, but the general idea is to have a disk held in place by actual masking tape:

OMTech 60W laser beam test - mirror 1
OMTech 60W laser beam test – mirror 1

Admittedly, orienting the graticule requires a bit of dexterity, but getting it pretty close is pretty easy.

Set the laser to fire a single 10 ms pulse when you press the front-panel button, thereby toasting a spot at the most intense part of the beam:

OMTech 60W laser beam test - mirror 1 fired
OMTech 60W laser beam test – mirror 1 fired

Repeat to record the beam position at all three mirrors:

OMTech 60W laser beam test - mirror 3 fired
OMTech 60W laser beam test – mirror 3 fired

The focal point target serves to verify the focused beam size and its alignment with respect to the aiming laser spot:

OMTech 60W laser beam test - focus point
OMTech 60W laser beam test – focus point

That target came from a scrap of cardboard while I was figuring out how to make the things.

All in all, OMTech did a pretty good job of aligning the beam, although the red laser dot needed a nudge. Now I have a record of where the beam was before I mess with clean the mirrors and lenses.

The SVG image as a GitHub Gist:

Sorry, something went wrong. Reload?
Sorry, we cannot display this file.
Sorry, this file is invalid so it cannot be displayed.

4 thoughts on “OMTech 60 W Laser: Beam Alignment Check Targets

    1. I was thinking more along the lines of dominating the worldwide market for new-production plastic slide rules … [grin]

Leave a Reply to tantris Cancel reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s