Archive for January 24th, 2020

CNC 3018XL: Pilot V5RT Pen Holder Lock Screw

Flushed with success about the MPCNC drag knife locking screw, I installed a similar screw on the V5RT pen holder for the CNC 3018:

Pilot V5RT holder - lock screw insert - assembled
Pilot V5RT holder – lock screw insert – assembled

A dark ring of epoxy around the screw holds a shortened M3 brass insert in place:

Pilot V5RT holder - lock screw insert
Pilot V5RT holder – lock screw insert

As it turned out, the original recess left only a few threads for the M3 SHCS, so the much longer screw wobbulated alarmingly. I drilled out the threads, turned the knurls off the insert, shortened it a bit, masked the pretty knurls on the aluminum ring, then glopped the insert in place while the Sherline held the screw vertical:

Pilot V5RT holder - insert epoxy
Pilot V5RT holder – insert epoxy

While I was at it, I added a thin ring of foam rubber under the knurled ring to keep it from clacking against the upper bushing.

Now I can’t lose the hex wrench when I take the thing out for Show-n-Tell sessions …

,

Leave a comment