Archive for January 21st, 2020

MPCNC Drag Knife Holder: Lock Screw

While calibrating the MPCNC’s probe camera offset for the drag knife holder, this happened:

Drag Knife - vertical escape
Drag Knife – vertical escape

Well, at least it’s centered on the target:

Drag Knife - vertical escape - detail
Drag Knife – vertical escape – detail

This happened a few times before, because my fingers don’t fit neatly inside the drag knife holder to tighten the lock ring:

Drag Knife - LM12UU ground shaft - assembled
Drag Knife – LM12UU ground shaft – assembled

[Update: The lock ring keeps the holder at a fixed position inside the 12 mm shaft and doesn’t affect the blade directly. When the ring works loose, the threaded holder can rotate to expose more blade and, in this case, stab deeper into the target. ]

So I turned & knurled an aluminum ring, then tapped a 3×0.5 mm hole for a lock screw plucked from the Drawer o’ Random M3 Screws:

Drag Knife - lock screw - side
Drag Knife – lock screw – side

A view looking along the screw shows a bit more detail around the spring:

Drag Knife - lock screw - front
Drag Knife – lock screw – front

The general idea is to set the blade extension, then tighten the lock screw to hold it in place, without relying on the original brass lock ring, shown here while cutting a boss for the spring:

Drag Knife - turning spring recess
Drag Knife – turning spring recess

The lock screw’s knurled handle just barely kisses the NPCNC’s black tool holder ring, so my guesstimated measurements were a bit off. Clamping the knife holder one itsy higher in the tool holder solved the problem.

I cranked on 300 g of spring preload and, squashed like that, the spring’s rate is now 75 g/mm. Cutting at Z=-1 mm should suffice for laminated paper slide rule decks.

The original sizing doodle:

Drag Knife Holder - lock screw ring doodle
Drag Knife Holder – lock screw ring doodle

The short 18 mm section clears the inside of the LM12UU bearing, although it could be a millimeter shorter. The 19 mm section comes from the 3/4 inch aluminum rod I used, skim-cut to clean it up.

If I ever remake this thing, it needs a major re-think to get all the dimensions flying in formation again.

, , , ,

2 Comments