Archive for September 26th, 2019
A slight modification to the MPCNC LM12UU collet pen holder turns it into a long-reach Z-Axis Height Probe:
A flange on the top plate holds a Makerbot-style endstop switch:
The brass probe rod sports a 3/32 inch ball epoxied on its tip, although for my simple needs I could probably use the bare rod:
I clamped the rod to extend a bit beyond the plate, where it can soak up most of the switch release travel, leaving just enough to reset the clickiness after each probe:
The probe responds only to Z motion, not tip deflection in XY, so it’s not particularly good for soft objects with sloped sides, like the insole shown above. It works fine for rigid objects and should suffice to figure the modeling workflow.
The bCNC Auto-Level probe routine scans a grid over a rectangular region:
Which Meshlab turns into a solid model:
That’s the bottom of the insole probed on a 5 mm grid, which takes something over an hour to accomplish.
The OpenSCAD code as a GitHub Gist: