Archive for February 14th, 2019
Flushed with success from engraving a hard drive platter for the 21HB5A tube, I bandsawed an acrylic square from a scrap sheet and unleashed the diamond drag bit on it:
That’s side-lit against a dark blue background. The long scratch and assorted dirt come from its protracted stay in the scrap pile.
If you look closely, you’ll see a few slightly wider loops, which came from a false start at Z=-0.1 mm.
Engraving at -0.5 mm looked pretty good:
Despite an angular resolution of 2°, the curves came out entirely smooth enough. The gritty scratchiness resulted in a pile of chaff covering the engraved area; perhaps some oil or lube or whatever would help.
Rescaling the pattern to fit a CD platter worked fine, too:
Polycarbonate seems to deform slightly, rather than scratch, leaving the final product with no chaff at all:
In this case, the doubled lines come from the reflection off the aluminized lower surface holding all the data.
That CD should be unreadable by now …