Archive for December 12th, 2018
Adapting the NP-BX1 battery holder to use SMT pogo pins worked well:
The next step is to add sockets for those 14 AWG wires:
Start by reaming / hand-drilling all the holes to their nominal size and cleaning out the pogo pin pocket.
Solder wires to the pogo pins and thread them through the holder and lid:
That’s nice, floppy silicone-insulated 24 AWG wire, which may be a bit too thick for this purpose.
The pogo pins will, ideally, seat with the end of the body flush at the holder wall. Make it so:
Dress the wires neatly into their pocket:
Butter the bottom of the lid with epoxy, clamp in place, set it up for curing, then fill the recess:
While it’s curing, make a soldering fixture for the 14 AWG wires:
The holes are on 5 mm centers, in the expectation other battery holders will need different spacing.
Solder it up and stick the wires into the base:
Jam a battery in and It Just Works™:
- Green = supply current at 20 mA/div
- Yellow = LED driver transistor base voltage
- Purple = other transistor collector voltage
- White = base – collector voltage = capacitor voltage
The measurement setup was a bit of a hairball:
For completeness, here’s the schematic-and-layout diagram behind the circuitry:
I love it when a plan comes together!
The OpenSCAD source code as a GitHub Gist: