Presta Valve to Schraeder Hole Adapter

The front rim on my Tour Easy developed a distinct bulge, of the sort usually caused by ramming something, but I’m not Danny McAskell and the bulge got worse over the course of a few weeks, suggesting the rim was deforming under tire pressure. Having ridden it upwards of 35 k miles with plenty of trailer towing and too much crushed-stone trail riding, the brake tracks were badly worn and it’s time for a new rim.

An Amazon seller had an identical (!) rim, except for the minor difference of having a hole sized for a Schraeder valve stem, rather than the Presta valves on the original rims. One can buy adapters / grommets, but what’s the fun in that?

The brake track walls are 1.5 mm thick on the new rim and a scant 1.0 mm on the old rim, so, yeah, it’s worn.

A few measurements to get started (and for future reference):

Presta to Schraeder Adapter - dimension doodle
Presta to Schraeder Adapter – dimension doodle

If you don’t have an A drill, a 15/64 inch drill is only half a mil larger and, sheesh, anything close will be fine.

Introduce a suitable brass rod to Mr Lathe:

Presta-Schraeder Adapter - parting off
Presta-Schraeder Adapter – parting off

Break all the edges and drop it in place:

Presta-Schraeder Adapter - installed
Presta-Schraeder Adapter – installed

One could argue for swaging the adapter to fit flush against the curved rim, but commercial adapters don’t bother with such refinements and neither shall I.

The 7.0 mm length got shortened to fit flush with the center of the rim:

Presta-Schraeder Adapter - valve stem installed
Presta-Schraeder Adapter – valve stem installed

It’s brass, because the rim is heaviest on the far side where the steel pins splicing the ends live, and, with the tube & tire installed, the rim came out almost perfectly balanced. Which makes essentially no difference whatsoever, of course.

The shiny new rim sports shiny new reflector tape (from the same stockpile, of course).

That was easy …