Archive for March 19th, 2017
I had to replace the faucet on a kitchen sink (not our own, for reasons not relevant here) after the steel nuts & washers holding the base to the sink deck rotted completely away. Why faucet manufacturers used plain steel in that location remains a mystery; I’m sure it has something to do with cost reduction and damn the consequences after a few years.
Of course, the new faucet didn’t sit quite flat on the sink deck, due to the raised rim around the perimeter. Installing it like that would prevent the (hard plastic) gasket from sealing against the deck, with the inevitable water leak below the sink; we started this project by scrapping a water-soaked shelf under the sink due to the previous faucet’s wrecked seal. Sliding the oval base forward enough to clear the rim would expose the two holes on each side, with similar results.
You can see the problem if you squint hard enough:
I decided raising the back of the base by maybe two millimeters wouldn’t be particularly visible, particularly if I filled the space with silicone snot (almost) matching the gasket to provide a solid foundation.
The blue tape masks the sink surface around the gasket to prevent silicone mishaps and simplify cleanup. I held the gasket in place, traced around it with new Xacto knife blade, and peeled the inside out just like I knew what I was doing.
Generous beads of snot around all the holes and across the back will provide a firm base and a good seal:
With that in place, I aligned the faucet over the gasket, gently tightened the nuts holding the base to the deck, and waited a day for the silicone to start curing before completing the plumbing. It’ll take a while to finish, due to the limited area exposed around the edges.
The water lines now have shutoff ball valves, which the next person to work on it will surely appreciate.