Archive for March 6th, 2017

Cheap WS2812 LEDs: Test Fixture Failure 1

Well, that didn’t take long:

WS2812 array - failure 1

WS2812 array – failure 1

The red spot in the next-to-bottom row of the test fixture (*) marks a failed WS2812 LED. All of the LEDs above it, plus the LED just to its left, are in pinball panic mode: random colors flicker across the panel as the LED’s controller transmits garbled data and the downstream LEDs pass it on.

This failure provides several bits of information:

  • The LED sees the same power supply as all the rest, so it’s not a power thing
  • The LED gets data from the adjacent WS2812, so it’s not an Arduino output thing
  • It failed after about four days = 100 hours of continuous operation

I connected the previous LED’s output (#6) to the next one’s input (#8), so the failed LED (#7, now with output disconnected) continues to flicker, but doesn’t influence any of the downstream LEDs.

(*) The LEDs are daisy-chained from lower right to upper left, row by row, so that’s LED #7 of 28.

Advertisements

11 Comments