# Archive for January 15th, 2015

### Monthly Image: Spherometer Measurements

Our Larval Engineer volunteered to convert the lens from a defunct magnifying desk lamp into a hand-held magnifier; there’s more to that story than is relevant here. I bulldozed her into making a solid model of the lens before starting on the hand-holdable design, thus providing a Thing to contemplate while working out the holder details.

That justified excavating a spherometer from the heap to determine the radius of curvature for the lens:

You must know either the average radius / diameter of the pins or the average pin-to-pin distance. We used a quick-and-dirty measurement for the radius, but after things settled down, I used a slightly more rigorous approach. Spotting the pins on carbon paper (!) produced these numbers:

The vertical scale has hard-metric divisions: 1 mm on the post and 0.01 on the dial. You’d therefore expect the pins to be a hard metric distance apart, but the 25.28 mm average radius suggests a crappy hard-inch layout. It was, of course, a long-ago surplus find without provenance.

The 43.91 mm average pin-to-pin distance works out to a 50.7 mm bolt circle diameter = 25.35 mm radius, which is kinda-sorta close to the 25.28 mm average radius. I suppose averaging the averages would slightly improve things, but …

The vertical distance for the lens in question was 0.90 mm, at least for our purposes. That’s the sagitta, which sounds cool enough to justify this whole exercise right there. It’s 100 mm in diameter and the ground edge is 2.8 mm thick, although the latter is subject to some debate.

Using the BCD, the chord equation applies:

• Height m = 0.90 mm
• Base c = 50.7 mm
• Lens radius r = (m2 + c2/4) / 2m = 357.46 mm

Using the pin-to-pin distance, the spherometer equation applies:

• Pin-to-pin a = 43.91 mm
• Sagitta h = 0.90 mm
• Lens radius R = (h/2) + (a2 / 6h) = 357.50 mm

Close enough, methinks.

Solving the chord equation for the total height of each convex side above the edge:

• Base c = 100 mm
• Lens radius r = 357.5 mm
• Height m = r – sqrt(r2 -c2/4) = 3.5 mm

So the whole lens should be 2 · 3.5 + 2.8 = 9.8 mm thick. It’s actually 10.15 mm, which says they were probably trying for 10.0 mm and I’m measuring the edge thickness wrong.

She submitted to all this nonsense with good grace and cooked up an OpenSCAD model that prints the “lens” in two halves:

Alas, those thin flanges have too little area on the platform to resist the contraction of the plastic above, so they didn’t fit together very well at all:

We figured a large brim would solve that problem, but then it was time for her to return to the hot, fast core of college life…