Advertisements

Archive for January 12th, 2010

Corelle Sliver

Mary found a sliver chipped from the outside edge of a Corelle dinner plate, which provides an opportunity to see something that’s normally invisible: the ceramic layer inside its glass coating.

Overall, the sliver is nearly two inches long and about the same width as the plate is thick.

Corelle sliver

Corelle sliver

Peering through the microscope at the left end, the glass layer is most obvious along the top edge. You can barely see it along the bottom, where the chip thins to a razor edge.

Corelle sliver - detail

Corelle sliver - detail

On the right end the upper and lower glass layers are a bit more obvious, at least with the light arriving nearly horizontally and after some aggressive exposure hackage,

Corelle sliver - side light

Corelle sliver - side light

The ceramic has a slightly higher coefficient of thermal expansion than the glass, so it puts the glass under a tremendous amount of compressive stress as the newly manufactured plate cools. Glass is really strong in compression (and terribly weak in tension), so the plate becomes remarkably hard to break. More details there and there.

The plate rims do tend to chip, however, if you own them as long as we have. These are the long-discontinued Old Town Blue pattern: over three decades old by now.

Oddly, they’re still under warranty: back in the day, Corning sold its then-new Corelle with a Lifetime Warranty. Nowadays, you get three years for the mid-grade line, five years for thicker plates, and a mere one year for stoneware (whatever that is). I suppose enough people actually took them up on the warranty to make it economically impractical.

I ran a fine diamond file over the chipped edge and it’s OK. Eventually, we’ll break down and get new plates, but there’s no sense rushing a decision like that…

Advertisements

3 Comments